BMW 7 Series: Cockpit
READ NEXT:
In the vicinity of the steering wheel
Vehicle features and options
This chapter describes all standard, country-specific
and optional features offered with the series.
It also describes features and functions that are
not necessarily ava
In the vicinity of the center console
Control Display
Ventilation
Hazard warning system
Intelligent Safety
Glove compartment
Radio/multimedia, see Owner's Manual for
Navigation, Entertainment, and Communication
Automatic clima
SEE MORE:
Steering Arms, Tie Rods, Steer. Damper
INSTRUCTIONS FOR REMOVING AND INSTALLING EAR CLIPS
Notes
NOTE: The work steps are show on assorted components.
Ear clip must always be replaced.
To remove an ear clip, place special tool 32 1 260 at right angles to ear and
cut ear open.
Fig. 75: Removing Ear Clip Using Special Tool (32 1 260)
The
Replacing Crankshaft Pulse Generator (N63)
Necessary preliminary work
Read out the fault memory of the DME control unit.
Switch off ignition.
Remove rear UNDERBODY PROTECTION.
Installation location
On transmission housing at bottom right.
Release connector (1) and remove.
Release screw (2).
Tightening torque 13 62 4AZ.
Withdraw puls
© 2019-2026 Copyright www.bmw7g11.com
