BMW 7 Series: Cross traffic warning- Warning
General information
The respective display is called up on the Control Display. A signal tone may sound and the light in the exterior mirror may flash.
Light in the exterior mirror
.gif)
The light in the exterior mirror flashes if vehicles are detected by the rear sensors and your own vehicle is moving backwards.
Display in the PDC Park Distance Control view
.gif)
In the PDC Park Distance Control view, the respective boundary area flashes red, if vehicles are detected by the sensors.
Display in the camera view
.gif)
The respective boundary area, arrow 1, in the camera view flashes red, if vehicles are detected by the sensors.
Yellow lines, arrow 2, mark the bumper of your own vehicle.
Acoustic warning
In addition to the optical indicator, a warning signal sounds if your own vehicle moves into the respective direction.
System limits
The system may not be fully functional in the following situations:
- If the speed of the approaching vehicle is very high.
- In heavy fog, wet conditions, or snowfall.
- In tight curves.
- If the bumper is dirty, iced up, or covered, for instance by stickers.
- If the field of view of the sensors is covered, e.g., by garage walls, hedges or snow hills.
- If cargo protrudes.
- When crossing objects move at a very slow speed.
- If other objects are in the capture range of the sensors, that hide cross traffic.
READ NEXT:
Chassis components
Vehicle features and
options
This chapter describes all standard, country-specific
and optional features offered with the series.
It also describes features and functions that are
not necessarily ava
Adaptive chassis
Concept
This system reduces undesirable vehicle motion
when using a dynamic driving style or traveling
on uneven road surfaces.
General information
The driving dynamics and driving comfort are enhance
SEE MORE:
More Functions
Bi-xenon Headlights
Bi-xenon headlights are installed as standard equipment and are located in
the outer chamber of the headlights.
In connection with the bi-xenon headlights, the shutter for the low beam light
is activated by the "high beam
ON" signal thus enabling the high beam light. High beam
Removing And Installing Operating Unit For Additional Seat
Functions
Notes
Release latch mechanism (1) on operating unit (2) using special tool 64 1 020. At same time carefully lever out
operating unit (2) using special tool 00 9 317.
Disconnect plug connection behind and remove operating unit (2).
Fig. 208: Releasing Latch Mechanism On Operating Unit Using Special
