BMW 7 Series (G11/G12) 2015-2022 Owners Manual / Mobility / Replacing components
BMW 7 Series: Replacing components
Vehicle features and options
This chapter describes all standard, country-specific and optional features offered with the series.
It also describes features and functions that are not necessarily available in your vehicle, e.g., due to the selected options or country versions. This also applies to safety-related functions and systems.
When using these functions and systems, the applicable laws and regulations must be observed.
Vehicle tool kit
.gif)
The onboard vehicle tool kit is located in the left storage compartment of the cargo area.
READ NEXT:
Wiper blades
Safety information
NOTICE
The window may sustain damage if the wiper
falls onto it without the wiper blade installed.
There is a risk of damage to property. Hold the
wiper firmly when changing the wi
Vehicle battery
General information
The battery is maintenance-free.
More information about the battery can be requested
from a dealer's service center or another
qualified service center or repair shop.
Safety info
Fuses
General information
The fuses are located at different places in the
vehicle.
Safety information
Warning
Incorrect and repaired fuses can overload electrical
lines and components. There is a risk of
f
SEE MORE:
Replacing Center Mount Gaiter
Necessary preliminary work
Remove PROPELLER SHAFT.
NOTE: The propeller shaft is balanced.
The front and rear propeller shafts must be reassembled in the same position.
Detach gaiter (1) from groove (2).
Mark front propeller shaft (3) and rear propeller shaft (4) in one plane.
Fig. 25: Marking
Stabilizer Bar
REMOVING AND INSTALLING/REPLACING ANTI-ROLL BAR LINK (STABILIZER
LINK) FOR LEFT/RIGHT STABILIZER
IMPORTANT: Observe SAFETY INSTRUCTIONS for raising the vehicle
Unscrew nuts (1).
Remove anti-roll bar link (2).
Installation note:
Replace self-locking nut.
Tightening torque 31 35 2AZ.
Fig. 79: Iden
© 2019-2026 Copyright www.bmw7g11.com
