BMW 7 Series: Standby state
Concept
When standby state is switched on, most functions can be used while the vehicle is stationary.
Desired settings can be adjusted.
General information
The vehicle is in the standby state after the front doors are opened from the outside.
Display in the instrument cluster
.gif)
OFF is displayed in the
instrument
cluster. The drivetrain is
switched off and standby state
switched on.
Drive-ready state
Concept
Switching on drive-ready state corresponds to starting the engine.
General information
Some functions, such as DSC Dynamic Stability Control, can only be used with drive-ready state switched on.
Safety information
.gif)
DANGER
If the exhaust pipe is blocked or ventilation is insufficient, harmful exhaust gases can enter into the vehicle. The exhaust gases contain pollutants which are colorless and odorless. In enclosed areas, exhaust gases can also accumulate outside of the vehicle. There is danger to life. Keep the exhaust pipe free and ensure sufficient ventilation.
.gif)
Warning
An unsecured vehicle can begin to move and possibly roll away. There is a risk of accident.
Before exiting, secure the vehicle against rolling.
In order to ensure that the vehicle is secured against rolling away, follow the following:
- Set the parking brake.
- On uphill grades or on a downhill slope, turn the front wheels in the direction of the curb.
- On uphill grades or on a downhill slope, also secure the vehicle, for instance with a wheel chock.
.gif)
NOTICE
In the case of repeated starting attempts or repeated starting in quick succession, the fuel is not burned or is inadequately burned. The catalytic converter can overheat. There is a risk of damage to property. Avoid repeated starting in quick succession.
Switching on drive-ready state
Concept
.gif)
Drive-ready state is switched on
via the Start/Stop button.
Steptronic transmission
- Depress the brake pedal.
- Press the Start/Stop button.
The ignition is activated automatically for a brief time and is stopped as soon as the engine starts.
Most of the indicator/warning lights in the instrument cluster light up for a varied length of time.
Gasoline engine
Depending on the motorization, the full drive power may not be available for approximately 30 seconds after starting the engine. In this case, the vehicle will not accelerate as usual.
Display in the instrument cluster
When drive-ready state is switched on, the tachometer shows the current engine speed.
Switching off drive-ready state
Steptronic transmission
- Engage selector lever position P with the vehicle stopped.
- Press the Start/Stop button.
The engine is switched off. The vehicle switches into standby state.
- Set the parking brake.
READ NEXT:
Operating concept
Vehicle features and
options
This chapter describes all standard, country-specific
and optional features offered with the series.
It also describes features and functions that are
not necessarily ava
Status information
General information
The status field can be found in the upper area of
the Control Display. Status information is displayed
in the form of symbols.
Radio symbols
Symbol /Meaning
HD Radio station is be
SEE MORE:
Integral Active Steering
Concept
The Integral Active Steering increases the maneuverability
and makes a more direct steering
response possible.
General information
Integral Active Steering is a combination of variable
steering ratio and rear axle steering.
The steering is more direct because the variable
steering ratio amp
Removing And Installing Automatic Transmission
REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (GA6HP26Z) (N63)
Notes
IMPORTANT: After completion of work, check TRANSMISSION OIL LEVEL.
Use only the approved TRANSMISSION FLUID.
Failure to comply with this requirement will result in serious damage to the
automatic transmission!
Necessary prelimi
