BMW 7 Owners & Service Manuals

BMW 7 Series: Steering Column

READ NEXT:

 Electrical Steering Column Adjustment Normalization

NOTE: Normalization must be carried out after the following work: Removal or replacement of control panel in heater-A/C system or of steering column Repair work to electric steering column adjustm

 Removing And Installing/Replacing Steering Column

IMPORTANT: To avoid damaging the coil spring cassette, it is necessary to remove the steering wheel because of the absence of a steering column lock! Necessary preliminary tasks Move steering colum

 Replacing Steering Shaft Sleeve

Necessary preliminary tasks: Remove stiffening plate (all N73/S63 and F12 N63) Remove EXHAUST SYSTEM (only N63/N73/S63) Remove CATALYTIC CONVERTERS CYLINDERS 5-8 (only N63/N73/S63) Remove heat sh

SEE MORE:

 Safety belts

Number of safety belts and safety belt buckles The vehicle is fitted with four or five safety belts to ensure occupants' safety. However, they can only offer protection when adjusted correctly. The two outer safety belt buckles of the rear seats are intended for the persons sitting on the left and

 Adjusting Gear Lever (Parking Lock Emergency Release)

NOTE: Check cable for ease of movement. Move gear selector switch to "P" position. Control for emergency release must not be actuated. Unfasten nut. Disconnect cable (1). Installation: Release nut Adjust cable by means of holder (2) until spacing A > or = 1 mm is obtained. Tighten down n

© 2019-2026 Copyright www.bmw7g11.com