BMW 7 Series: USB port
General information
Follow the information regarding the connection
of mobile devices to the USB port in the section
on USB connections.
Additional information:
USB connections
In the center armrest
.gif)
A USB port is located in the center armrest.
Properties:
- USB port Type C.
- For charging mobile devices and for data
transfer.
- Charge current: max. 3 A.
In the front center console
NOTICE
Objects in the storage compartment, e.g., large
USB connectors, may block or damage the
cover when it is being opened or closed. There
is a risk of damage to property. Make sure that
the area of movement of the cover is clear
while opening and closing it.
.gif)
- Push the cover forward until it engages behind
the cup holders.
- Push the cover forward again until it engages
behind the storage compartment.
.gif)
A USB port is located in the center console.
Properties:
- USB port Type A.
- For charging mobile devices and for data
transfer.
- Charge current: max. 1.5 A.
In the rear center console
.gif)
Two USB ports are located in the center console
in the rear passenger compartment.
Properties:
- USB port Type C.
- For charging of mobile devices.
- Charge current: maximum 3 A per port.
READ NEXT:
Concept
The wireless charging tray enables the following
functions to be performed without cables:
Charging the rechargeable battery of a mobile
phone with Qi capability and of other mobile
device
General information
If the vehicle is equipped with the forgotten
warning function, a warning can be output if a
mobile phone with Qi capability was forgotten in
the wireless charging tray when leavin
General information
There is a folding table in the center armrest of
the rear console.
Safety information
Warning
A folded-out folding table protrudes into the
car's interior and, in case of accident
SEE MORE:
IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC
DISCHARGE (ESD PROTECTION).
Necessary preliminary work
Disconnect BATTERY EARTH LEAD
RELEASE LEFT FRONT SEAT and tilt towards rear
Remove front left DOOR SILL COVER STRIP
Remove footwell SIDE TRIM PANEL on A-pillar
Remov
Read contents of BODY, GENERAL.
STRIP DOWN VEHICLE
Observe new procedure for bonding and riveting (REPAIR STAGE 2).
Following new body parts are required:
End of luggage compartment floor
Following consumables are required:
MATERIAL CHART
Fig. 349: Identifying End Of Luggage Compartment Floor