BMW 7 Series (F01/F02) 2008-2015 Service Manual / General Vehicle Electronics / Wiper/Washer System
BMW 7 Series: Wiper/Washer System
- Introduction
- System Overview
- Functions
- Wash Functions
- System Components
- Wiper Switch on the Steering Column Stalk
- Wiper Motor
- Service Information
READ NEXT:
Introduction
Windscreen Wipers
The F01/F02 has a wiper/washer system for the windscreen as standard.
Windscreen wiping has the following functions:
Continuous wipe in stage 1
Continuous wipe in stage 2
Flick
System Overview
Fig. 79: Rain/Lights/Solar/Condensation Sensor System Overview
COMPONENTS DESCRIPTION CHART
Front wiper motor with wiper
Outside temperature sensor
Heated washer jet 3x (1)
Headlight washer syst
Functions
Wiping
The wiper/washer system is switched on and off with the wiper switch. The
wiper switch is an integral part of
the steering column switch cluster SZL.
Wiper Switch
The wiper switch on the steer
SEE MORE:
Replacing Pipes For Air Springs
WARNING: Risk of injury!
Drain the air spring system before carrying out any work on the air supply
unit, air pipes and air springs! Danger of injury if this instruction is not
complied with!
Risk of damage!
Extreme cleanliness must be ensured in the connection area of the pipes during
removal and
Additional Work For Camber Correction
IMPORTANT: Changes in axle geometry caused by accidents must under no
circumstances
be rectified by camber adjustment!
NOTE: The upper control arm may only be replaced if the camber is outside
the
specified tolerance after toe adjustment.
Adjust TOE-IN.
Check camber values; if necessary, replace
© 2019-2026 Copyright www.bmw7g11.com
