BMW 7 Series (F01/F02) 2008-2015 Service Manual / General Vehicle Electronics
BMW 7 Series: General Vehicle Electronics
- Comfort Access
- Central Locking System
- Automatic Soft Close
- Power Windows
- Sliding Tilting Sunroof
- Anti-Theft System
- Automatic Luggage Compartment Lid Actuating System
- Introduction
- System Overview
- Functions
- Automatic Opening
- Automatic Closing
- System Components
- Service Information
- Exterior Lighting
- Introduction
- System Overview
- Functions
- Light Functions
- Low Beam Headlight
- Hazard Warning Lights
- More Functions
- Visual Alarm/Feedback
- Zero Position Sensor
- Headlight Driver Module
- Turning Lights
- Service Information
- Interior Lighting
- Wiper/Washer System
- Introduction
- System Overview
- Functions
- Wash Functions
- System Components
- Wiper Switch on the Steering Column Stalk
- Wiper Motor
- Service Information
- Exterior Rear View Mirrors
- Seats
- Introduction
- System Overview
- Functions
- Front Seat Memory Function
- Front Seat Heating
- Front Lumbar Support
- Seat Heating In The Rear Basic Seat
- Other Seat Functions
- Seat Heating In The Rear-Compartment Comfort Seat
- Lumbar Support In The Rear-Compartment Comfort Seat
- Massage Function In Rear-Compartment Comfort Seat
- System Components
- Service Information
- Steering Column Switch Cluster
READ NEXT:
Introduction
Keyless Vehicle Access
Using Comfort Access, the customer can unlock and open the vehicle without
active use of the ID transmitter.
Access to the vehicle can be gained from any point. It is importan
System Overview
Input/Output - Comfort Access
Fig. 1: Comfort Access Input/Output Diagram
COMPONENTS DESCRIPTION CHART
CAS 4 Car Access System 4
Footwell module (FRM)
Junction box electronics (JB)
Emergency sta
SEE MORE:
Repair Work On GFP Components With Gelcoat Surface
Scratches in Gelcoat surface
Scratches in the Gelcoat surface which do not allow the GFP mat structure to
show through can be touched up.
Sand out scratches with water and 800 wet sandpaper. Then sand with water and
2000 wet sandpaper. Prepare
repair area for polishing.
Cracks in Gelcoat surface
Separating Cut Determination With A Template
In the case of a partial replacement piece, a body component is cut at a
point described in the repair instructions.
A template may be used for the exact position determination for the separating
cut.
The template is made from the reinforcement plate and can be reused.
Carry over schematic diag
© 2019-2026 Copyright www.bmw7g11.com
