BMW 7 Series (F01/F02) 2008-2015 Service Manual / General Vehicle Electronics / Automatic Soft Close
BMW 7 Series: Automatic Soft Close
READ NEXT:
Introduction
F01/F02 Available with Automatic Soft Close Function
The Automatic Soft Close function (SCA) is available and can be ordered as of
volume production launch.
The Automatic Soft Close function require
System Overview
System Circuit Diagram for Automatic Soft Close Function
Fig. 17: Automatic Soft Close Function System Circuit Diagram
COMPONENTS DESCRIPTION CHART
Footwell module (FRM)
Junction box module (JB)
Functions
Automatic Soft Close
The Automatic Soft Close function is an autonomous function. The only
connection to the car's electrical
system is Terminal 30 basic mode (Terminal 30B) and the ground connection
SEE MORE:
Rear collision preparation
Concept
The system reacts to vehicles approaching from
behind.
General information
Two radar sensors in the rear bumper monitor
the area behind the vehicle.
When a vehicle approaches from the rear at a
certain speed, the system responds as follows:
Active Protection: when a collision seems to
Replacing Left Control Sensor (N63)
Notes
WARNING: Risk of burning!
Only perform this work after engine has cooled down.
Necessary preliminary work
Check function of DME control unit
Switch off ignition
Remove AIR FILTER HOUSING
Unlock plug connection and detach.
Unclip control sensor cable at retaining clips.
Release control se
© 2019-2026 Copyright www.bmw7g11.com
