BMW 7 Series: Mechanical Attachments
REPLACING SELECTOR SHAFT SEAL (GA6HP26Z)
Notes
IMPORTANT: After completion of work, check TRANSMISSION OIL LEVEL.
Use only the approved TRANSMISSION FLUID.
Failure to comply with this requirement will result in serious damage to the automatic transmission!
Necessary preliminary tasks
- Remove rear UNDERBODY PROTECTION
- Remove left retaining plate
AWD - remove right retaining plate
IMPORTANT: Support transmission with workshop hoist.
Unfasten nut.
Remove cable (1).
Installation:
Adjusting cable:
- Release nut
- Adjust cable by means of holder (2)
.png)
Fig. 42: Identifying Cable With Holder
Distance A = 1 mm.
Unfasten nut.
Take off holder (1).
Tightening torque 24 51 1AZ.
.png)
Fig. 43: Identifying Holder Nut
Screw in special tool 24 5 361 until it is firmly connected with radial shaft seal.
.png)
Fig. 44: Connecting Radial Shaft Seal Using Special Tool 24 5 361
Screw special tool 24 5 362 onto special tool 24 5 361 and tighten down.
This pulls the shaft seal out of the transmission housing.
.png)
Fig. 45: Tightening Special Tool 24 5 362 Onto Special Tool 24 5 361
Oil sealing lip on shaft seal (1).
Screw in radial shaft seal (1) with special tools 24 5 366 and 24 5 364 as far as it will go.
.png)
Fig. 46: Tightening Radial Shaft Seal Using Special Tools 24 5 366 And 24 5
364
READ NEXT:
Hydr/El Control Components/Elements
REPLACING OIL ACCUMULATOR (GA8HP45Z)
Do not let skin come in contact with transmission oil and do not inhale
fuel vapors.
Wear protective gloves.
Ensure adequate ventilation.
IMPORTANT: Applies
Oil Pump
REPLACING O-RING ON OIL PUMP (GA6HP19/GA6HP26Z
Notes
IMPORTANT: After completion of work, check TRANSMISSION OIL LEVEL.
Use only approved TRANSMISSION OIL.
Failure to comply with this instruction wi
Controller
MANUAL EMERGENCY RELEASE OF TRANSMISSION LOCK
Manual emergency release of transmission lock from inside vehicle is not
possible with GA6HP/GA8HP gearboxes from
03/2010
From production date 04/2010
SEE MORE:
Notes On Adhesive K1
IMPORTANT: Note the following information before starting to apply
adhesive!
Country-specific safety and industrial safety regulations
Material safety data sheet of manufacturer
Processing instructions on glue cartridge
Storage
Dry at 15º- 25ºC.
Shelf life
The glue cartridge is marked with a
Stationary Wheel Balancing
Necessary preliminary work
Remove WHEEL
IMPORTANT: Use only BMW-approved balance weights.
Remove any fitted balancing weights, stones in tread pattern and larger
contaminants.
Check tire inflation pressure and tire for condition, damage, flat spots
(out-of-round caused by e.g. parking of
vehic
