BMW 7 Series: Notes On Adhesive

 Use Of Materials In Outer Skin

The following illustration is a schematic representation of all the body variants. Apply this illustration to the relevant vehicle. Fig. 76: Identifying Vehicle Components All components not listed in the table below are composed of established sheet steel qualities. MATERIAL CHART VEHICLE IDE

 Replacing Center Mount Gaiter

Necessary preliminary work Remove PROPELLER SHAFT. NOTE: The propeller shaft is balanced. The front and rear propeller shafts must be reassembled in the same position. Detach gaiter (1) from groove (2). Mark front propeller shaft (3) and rear propeller shaft (4) in one plane. Fig. 25: Marking