BMW 7 Owners & Service Manuals

BMW 7 Series: Open-End Wrench

Minimum set: Mechanical tools Open-end wrench MW

Note: Open-end spanner SW50 with retaining clip For releasing and tightening down the insert nuts for the screw connection of the propeller shaft on the rear axle final drive.

Storage Location

A18

SI number

01 21 06 (300)

Rear Axle
Fig. 32: Identifying Open-End Wrench (335040)

Consisting of:

2 = 0495582 Retaining bracket

3 = 0495583 Pin

NOTE: (Pin with chain (2 x) )

1 = 0495581 Basic body

RING SPANNER

Minimum set: Mechanical tools Ring spanner MW

Note: Multi-tooth ring spanner SW65 For releasing and tightening down flange nut on rear axle final drive.

Storage Location

A18

SI number

01 21 06 (300)

Rear Axle
Fig. 33: Identifying Ring Spanner (335050)

SLEEVE

Sleeve MW

Note: For fitting tapered roller bearing on drive pinion

Storage Location

C16

Rear Axle
Fig. 34: Identifying Sleeve (331020)

SOCKET NUT

Minimum set: Mechanical tools Socket nut MW

Note: Socket nut z37 For counter-holding rear axle gearbox input shaft when releasing and tightening down flange nut.

Storage Location

A25

SI number

01 18 08 (482)

Rear Axle
Fig. 35: Identifying Socket Nut (335090)

SOCKET NUT

Minimum set: Mechanical tools Socket nut MW

Note: Socket nut z37 For counter-holding rear axle gearbox input shaft when releasing and tightening down flange nut.

Storage Location

A25

SI number

01 18 08 (482)

Rear Axle
Fig. 36: Identifying Socket Nut (335090)

    READ NEXT:

     Spindle

    Spindle MW Note: (Spindle with nut) For device 33 0 000, for removing and installing rubber mounts of rear axle support mounting. Storage Location C25 B25 SI number 01 18 08 (482) Consisting of: Fig

     Tool

    TOOL Tool MW Note: (Press-out/-in tool set) For pressing the rubber mount out of and into the control arm special tools 33 3 202 and 33 3 203 for E87 and E90 Storage Location B32 SI number 01 05 90 (

     Passive Restraints

    SEE MORE:

     Checking Setting Engine Emission

    SAFETY INFORMATION FOR WORKING ON VEHICLES WITH AUTOMATIC ENGINE START-STOP FUNCTION (MSA) WARNING: If the engine hood/bonnet contact is pulled upwards (workshop mode), the information "switch closed" is output. The automatic engine start-stop function is active. An automatic engine start is possi

     Driver profiles

    Concept Driver profiles can be created to store personal vehicle settings. If the vehicle is used by multiple drivers, each driver can create his personal driver profile. When a driver profile is selected, the vehicle will automatically apply the stored settings in the driver profile. General inform

    © 2019-2024 Copyright www.bmw7g11.com