BMW 7 Series: Vehicle Info Menu
BMW ASSIST Menu
The "Vehicle Info" menu contains all the information regarding the condition,
service intervals, the on-board
computer and the journey computer of the vehicle.
In addition, this menu contains for the first time a Quick Guide and the
electronic Owner's Handbook for the
vehicle.
NOTE: Certain services are not available to the customer before they have
been
enabled.
The main menu is displayed as of terminal 15 ON.
To call up the menu:
- Press the controller and then push it to the left
- Turn the controller until the desired function is highlighted, then
press to activate.
The first menu level contains the following submenus:
- Quick Guide
- Picture search
- Owner's Handbook
- On-board computer
- Journey computer
- Vehicle status.
Further entries or information are linked to each menu item.
Fig. 25: Display Vehicle Info Menu Screen
Settings Menu
The individual user settings can be defined in the Settings menu.
NOTE: Certain services are not available to the customer before they have
been
enabled.
The main menu is displayed as of terminal 15 ON.
To call up the menu:
- Press the controller and then push it to the left
- Turn the controller until the desired function is highlighted, then
press to activate.
The first menu level contains the following submenus:
- Head-Up Display
- Central screen
- Time/date
- Language/units
- Tone
- Limit
- Air conditioner
- Light
- Door locking
- Luggage compartment lid.
Further entries or information are linked to each menu item.
Fig. 26: Display Settings Menu Screen
READ NEXT:
Instrument Cluster
The instrument cluster is clipped into place in the dashboard with two clips.
A shroud prevents reflections in the
acutely angled windscreen.
The instrument cluster comprises the
Instrument Cluster Test Functions
The test functions are shown in the TFT display of the instrument cluster.
To Start Function Test
Terminal R ON or terminal 15 ON.
Press and hold the reset button
SEE MORE:
CARRYING OUT BATTERY "POWER RESET"
IMPORTANT: Observe SAFETY INSTRUCTIONS FOR HANDLING VEHICLE BATTERY.
The following steps must be carried out for a "power reset"
Switch off and disconnect battery charger
Turn off ignition
Vehicles with ID transmitter:
Remove identification sensor from slot
V
1.0 GENERAL INFORMATION
Brake fluid, (glycol-based) as used in BMW brake systems, must conform with
the following requirements:
High boiling point
Good low temperature resistance
Low compressibility
Corrosion inhibition for all metal parts inside of brake system
Compatibility with all rubber