BMW 7 Series (F01/F02) 2008-2015 Service Manual / Heating And Air Conditioning / Air Conditioning System
BMW 7 Series: Air Conditioning System
- A/C Performance Test (R 134a)
- Drawing Off, Evacuating And Filling Heating And Air Conditioning System (R 134a)
- Instructions For Handling R 134a Refrigerant
- Leak Detection With Forming Gas
- Leak Detection With Ultraviolet Additives (UV Additives) (BMW Leak-Testing Case)
- Overview Of Heater - A/C System Components
READ NEXT:
A/C Performance Test (R 134a)
Observe the following conditions prior to the A/C performance test
1. Provision of a diagnosis system. Safeguard electrical system integrity by
checking the fault memory (no
faults in the fault memor
Drawing Off, Evacuating And Filling Heating And Air Conditioning
System (R 134a)
WARNING: Only persons in possession of a professional certificate
of competence for the maintenance and repair of heating and air conditioning
systems are authorized to carry out repair work on the
Instructions For Handling R 134a Refrigerant
Work on the refrigerant circuit may only be carried out by experts!
Avoid all contact with liquid or gaseous R 134a. Wear safety goggles and
gloves when working on the
refrigerant circuit.
Follow S
SEE MORE:
Oil Pump
REPLACING O-RING ON OIL PUMP (GA6HP19/GA6HP26Z
Notes
IMPORTANT: After completion of work, check TRANSMISSION OIL LEVEL.
Use only approved TRANSMISSION OIL.
Failure to comply with this instruction will result in serious damage to the
transmission.
Necessary preliminary tasks
Remove AUTOMATIC TRAN
Removing And Installing/Replacing Front Left Or Right Seat Belt
Necessary preliminary tasks
Remove trim panels for door pillar.
Installation
Microencapsulated screws (Loctite) must be replaced and may not be
reused
Screw connection must be completed within 20 minutes (start of curing)
Microencapsulated screws must not be retightened
Clean thread of nut
© 2019-2026 Copyright www.bmw7g11.com
