BMW 7 Series (F01/F02) 2008-2015 Service Manual / General Vehicle Electronics / Sliding Tilting Sunroof
BMW 7 Series: Sliding Tilting Sunroof
READ NEXT:
Introduction
The F01/F02 with Slide/tilt Sunroof
The slide/tilt sunroof is an option on the F01/F02. Several control units are
involved in the operation of the
slide/tilt sunroof.
The roof control module control
System Overview
Input/output slide/tilt sunroof
Fig. 31: Slide/Tilt Sunroof Input/Output Diagram
COMPONENTS DESCRIPTION CHART
Footwell module FRM
Door contacts (4x) in the vehicle doors
Driver's door lock barrel
Functions
Overview
The roof control module receives signals from the other control units for the
functions of the slide/tilt sunroof.
The executing control unit is the roof control module. It controls the
sl
SEE MORE:
Removing And Installing Three-Hole Flange
Notes
IMPORTANT: It is absolutely necessary to replace the sunk nut!
The sunk nut already has a screw locking.
After the propeller shaft has been screwed into the rear axle final drive (sunk
nut), a hardening time of at least 2 hours is absolutely necessary.
The hardening time may be extended at l
Notes On Handling Optical Fibres
IMPORTANT: To avoid damage when handling optical fibres, comply with the
following
points:
The minimum permitted bending radius is 25 mm
Do not subject optical fibres to compressive and tensile load
Protect optical fibres against the effects of heat > or =85 ºC (e.g.
during
welding work,
© 2019-2026 Copyright www.bmw7g11.com
