BMW 7 Series: System Components
Spare Parts of Slide/tilt Sunroof
The slide/tilt sunroof in the F01/F02 consists The following table lists the most important of mechanical and electrical components.
COMPONENTS DESCRIPTION CHART
.png)
Electrical Components
The following graphic shows all the electrical components of the slide/tilt sunroof system together with the appropriate control units.
.png)
Fig. 33: Identifying Slide/Tilt Sunroof System Electrical Components
COMPONENTS DESCRIPTION CHART
- Car Access System
- Junction Box electronics
- Remote control receiver in Diversity module
- Footwell module
- Central gateway module
- Dynamic stability control
- Roof control module
- Door lock with door contact *Hall sensors, lock barrel, only driver's door
- Slide/tilt sunroof motor
Control Units
Car Access System 4
The Car Access System 4 issues the enable signal for the slide/tilt sunroof.
"Terminal 50 ON" status is sent via K-CAN2 while starting the engine. The roof control module prevents activation of the motors for the slide/tilt sunroof or interrupts current operation. This means that there is more energy available from the battery for the starter to start the engine.
Footwell module
The footwell module makes available the status of the door contacts and the driver's door lock barrel.
The footwell module also supplies the roof control module with information concerning the "Terminal 58g ON" status.
Roof control module
The roof control module contains the complete functions of the slide/tilt sunroof. The roof control module is always installed in connection with the slide/tilt sunroof.
The relays required to drive the slide/tilt sunroof motors are integrated in the roof control module.
Slide/tilt Sunroof Motors
One motor for the slide/tilt sunroof has two Hall sensors.
The Hall sensors are located on the motor shaft and are offset against one another by 90º.
When the motor is running, this results in two temporally offset Hall signals that are used to register the direction of rotation of the motor and for the anti-trapping protection function.
NOTE: Two motors are fitted to move the slide/. tilt sunroof.
READ NEXT:
Service Information
Initialization
Initialization of the slide/tilt sunroof involves the following procedures
that are necessary to ensure complete
functionality of the slide/tilt sunroof:
Normalization
Normalization
Introduction
Anti-theft System
The anti-theft system is available as an option. The task of the anti-theft
system is to indicate unauthorized
access to the vehicle by emitting an alarm. The alarm can be triggered
SEE MORE:
Leak Detection With Ultraviolet Additives (UV Additives) (BMW Leak-Testing
Case)
IMPORTANT: The UV leakage detection procedure is not permitted in EU
countries!
Observe national regulations in all other countries!
IMPORTANT: It is absolutely essential to read and comply with the
equipment manufacturer's
operating instructions use provided in the equipment case!
Read and comply
Shift Function
REPLACING EMERGENCY ACTUATOR
Necessary preliminary tasks
Remove CENTRE CONSOLE.
Remove rear UNDERBODY PROTECTION.
Remove left retaining plate from underbody protection.
Support transmission with lifter.
Remove TRANSMISSION CROSSMEMBER.
Remove transmission support bracket.
Unfasten nut.
Remo
